Arraysync software9/3/2023 ![]() Use ArrayShaker to break up your media into multiple segments and distribute them to ArraySync Clients powering your displays. Synchronize two displays or a hundred! ArraySync's performance is limited only by the capabilities of your hardware.ĪrraySync makes it easy to build a multi-screen video presentation. ArraySync is the ideal solution for event designers, trade shows, exhibitions and conferences.ĪrraySync is completely scalable, and can run entirely on hardware you already own. Play QuickTime content across multiple displays attached to one computer or over a local area network as if it were coming from a single video source. ![]() Is that correct? If so, what's an easy way to do that so that they match in size?Īlso, out of curiosity, is it a good or a bad idea to setup software raid for the swap partition? I originally setup two matching partitions on both drives, and having gone back and forth between them individually (running without one or another and then both again to see what happens) I'm now running with one of the original discs, one blank (which hasn't been added to any arrays yet or formated/partitioned) and the status of the md0 array shows "active raid1 sda1 9990080 blocks "Īnd the one for the swap partition shows "inactive sda5 (S) 492480 blocks".Top Software Keywords Show more Show lessĬreate dazzling multi-screen presentations with ArraySync, the network QuickTime synchronizer from The National Software Laboratory. The command you mentioned above made me think/realize that it would seem I have to recreate new partitions of the same size on the replacement disk before I can add those partitions to their respective arrays. Replacing disks in RAID5/6/10 arrays is equally easy to recover from.I'm still experimenting and decided the next thing I wanted to try and pretend a disk has completely failed and to replace it with a new, empty virtual disk of the same size as the old one. Any help would be greatly appreciated.Ĭode: mdadm -add /dev/md0 /dev/sdX1mdadm will know that it's missing a disk and automatically use this new disk to restore parity. I'm not sure if this is what is suppose to happen in real life or if this is a quirk happening because it was simulated in VBox or if there was something I was supposed to do after re-attaching the first "bad" drive. When I booted up this time it takes me to a prompt that says "Error: Disk missing" and then a grub> prompt with a blinking cursor. Shutdown, removed the secondary drive this time. I re-attached the primary, booted, no messages about RAID software anywhere along the way degraded mode or otherwise, looked normal. I though, "Let's see what happens when I do this" and decided to just create an empty folder on the desktop and shut back down (to see if it would sync up later with the missing drive after bring it back to the mix). I started the VM back up and it sat at a cursor for about 20 seconds but then some stuff whipped by and I noticed it said it was now running in a degraded mode, proceeded to boot up otherwise normal looking. I shut the VM off, opened up the storage settings menu and detached what was the primary drive (or rather, the drive that was on SATA port 0 the second drive being on port 1). After the system was alive I decided to do some testing. Setup and install was pretty simple and smooth. I just finished setting up a software RAID-1 array in Virtualbox with two 10 GB drives.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |